Search
Now showing items 1-10 of 85
A design example of an 8-pole radial AMB for flywheel energy storage
(
IEEE
, 2012 , Conference Paper)
High speed flywheel energy storage systems normally use magnetic bearings to reduce friction loss. Bearing load consists of radial forces with or without axial forces according to drive configuration and requirements. The ...
On the development of flywheel storage systems for power system applications: A survey
(
IEEE
, 2012 , Conference Paper)
Energy storage systems cannot be considered energy sources but having the ability of storing and discharging energy. They have a vital rule in the reliability and power quality of power systems. There are several energy ...
Performance of a five-phase boost inverter-fed submersible induction machine
(2013 , Conference Paper)
An electrical submersible pump (ESP) motor is preferably fed from a low voltage variable-frequency drive (VFD) followed by a step-up transformer. The motor and drive connection through a long feeder usually causes over ...
HVDC shunt tap based on series-input parallel-output DC-AC multi-module VSCs with DC voltages balancing
(
Institution of Engineering and Technology
, 2014 , Conference Paper)
Conventionally, tapping-off a small amount of power from an HVDC transmission line to a three-phase local network can be achieved using a DC-to-AC voltage source converter (VSC) followed by a step down transformer. In order ...
Medium voltage flywheel energy storage system employing dual three-phase induction machine with machine-side series-connected converters
(
Institution of Engineering and Technology
, 2014 , Conference Paper)
Flywheels as energy storage systems are good candidates for numerous power system applications such as voltage support, serving fluctuating loads, frequency regulation and renewable energy utilization. Most of these ...
Torque ripple reduction of radial magnetic gearbox using axial pole pairing
(
Institution of Engineering and Technology
, 2014 , Conference Paper)
Magnetic gearbox (MGB) is a contactless magnet-based transmission system that transmits mechanical power between two shafts. MGBs offer significant advantages over mechanical gears such as contactless power transfer, high ...
Traction system with on-board inductive power transfer
(
Institution of Engineering and Technology
, 2014 , Conference Paper)
In traction applications based on long primary and short secondary type, contactless electrical energy transmission can offer distinct advantages over the conventional energy transmission based on catenary system to provide ...
An asymmetrical six-phase induction motor drive based on nine-arm Modular Multilevel Converter (9AMMC) with circulating current suppression
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
Asymmetrical six-phase (dual three-phase) induction motors have received significant attention in high power medium voltage drive applications. Normally, two three-phase voltage source converters are used to supply the ...
A cascaded boost inverter-based open-end winding three-phase induction motor drive for photovoltaic-powered pumping applications
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
Although PWM inverter-fed drives are now a well-established technology in industrial applications, the generation of common mode voltage associated with these modulation techniques results in undesired bearing current and ...
High voltage pulse generator based on DC-to-DC boost converter with capacitor-diode voltage multipliers for bacterial decontamination
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
High voltage pulse generators can be used effectively in water treatment applications, as applying a pulsed electric field on the infected sample guarantees killing of harmful germs and bacteria. In this paper, a new high ...