Show simple item record

AuthorBuzatu P.
AuthorQiblawey H.
AuthorOdai A.
AuthorJamaleddin J.
AuthorNasser M.
AuthorJudd S.J.
Available date2020-02-24T08:57:11Z
Publication Date2018
Publication NameWater Research
ISSN431354
URIhttp://dx.doi.org/10.1016/j.watres.2018.07.019
URIhttp://hdl.handle.net/10576/12961
AbstractWhilst the fouling of MBR membrane surfaces has been very extensively explored by the academic community, there is an increasingly widespread recognition by practitioners of the issue of clogging of membrane channels with sludge solids, sometimes termed ?sludging?. The study undertaken has quantified this phenomenon using a bespoke test cell allowing a flat sheet membrane channel to be viewed directly during operation and the accumulated solids determined by digital image processing. Sludging behaviour has then been correlated both with the sludge properties, from sludge samples taken from both an industrial and municipal MBR, and the permeability decline rate data. The work has revealed the expected trends in fouling propensity, as quantified by the exponent n of the ?p/?t = m.exp(nJ) correlation from classical flux-step tests. With zero membrane aeration the industrial samples exhibited sludging, the filling of the complete thickness of the membrane channel with sludge solids, whereas for municipal sludge the solids formed a cake layer which did not fill the channel. In the absence of sludging the permeability decline followed the expected pattern of increasing at the elevated soluble COD and capillary suction time values of the industrial sludge, compared with municipal sludge at the same solids concentration range (8?12 g.L?1). However, there was no evident correlation between fouling (permeability decline without sludging) and sludging: incipient sludging did not appear to influence permeability, though can be assumed to negatively impact on long-term operation, or relate to the sCOD concentration. Sludging instead appeared to depend on the sludge physical properties, and primarily the viscosity: sludge samples at high viscosities were found to exhibit a different air-scour pattern to that at normal MLSS concentrations. Outcomes suggest that sludging is caused by rheological conditions promoting bubble coalescence and bubble stream constriction, reducing the exposure of the membrane surface to scouring air.
SponsorThis work was made possible by the support of a National Priorities Research Programme (NPRP) grant from the Qatar National Research Fund , grant reference number NPRP8-1115-2-473 . The statements made herein are solely the responsibility of the authors. The authors would like to thank Ashgal, Suez and Qatar Gas for their unstinting support of this work, as well as Kubota Membranes Europe for supplying the membranes and Yousef Elhamarnah for his assistance with the sampling.
Languageen
PublisherElsevier Ltd
SubjectClogging
SubjectFouling
SubjectMembrane bioreactors
SubjectRheology
SubjectSludge
SubjectSludging
TitleClogging vs. fouling in immersed membrane bioreactors
TypeArticle
Pagination46 - 54
Volume Number144


Files in this item

FilesSizeFormatView

There are no files associated with this item.

This item appears in the following Collection(s)

Show simple item record