Search
Now showing items 41-50 of 66
Performance of a three-To-five matrix converter fed five-phase induction motor under open-circuit switch faults
(
Institute of Electrical and Electronics Engineers Inc.
, 2016 , Conference Paper)
Multiphase machines are conventionally fed from voltage source inverters (VSIs) with bulky dc-link capacitors, which represent a technical drawback in high power medium voltage applications. Alternatively, multiphase matrix ...
A four-switch based long-cable-fed five-phase induction motor drive system
(
Institute of Electrical and Electronics Engineers Inc.
, 2016 , Conference Paper)
In applications where motors are fed from low voltage variable-frequency drive (VFD) through long cables, a step up transformer is commonly used to boost the converter output voltage in order to compensate for the cable ...
Effect of stator winding connection on performance of five-phase linear induction machines
(
Institution of Engineering and Technology
, 2016 , Conference Paper)
In electric traction, Linear Induction Motors (LIMs) have become a competitive alternative, especially for low speed applications where machines with short stators are commonly used. Due to driving dynamics tolerances, ...
A Nine-Switch-Converter-Based Integrated Motor Drive and Battery Charger System for EVs Using Symmetrical Six-Phase Machines
(
Institute of Electrical and Electronics Engineers Inc.
, 2016 , Article)
This paper presents a new configuration for integrated on-board battery chargers of electric vehicles (EVs) incorporating symmetrical six-phase machines. The configuration proposes an exclusive utilization of a nine-switch ...
Standard three-phase stator frames for multiphase machines of prime-phase order: Optimal selection of slot/pole combination
(
Institute of Electrical and Electronics Engineers Inc.
, 2019 , Article)
Multiphase machines have attracted significant attention in both academic and industrial sectors as candidates for high-power safety-critical applications as well as wind energy conversion systems. Undoubtedly, this interest ...
A Non-Isolated Hybrid-Modular DC-DC Converter for DC Grids: Small-Signal Modeling and Control
(
Institute of Electrical and Electronics Engineers Inc.
, 2019 , Article)
This paper presents small-signal modeling, stability analysis, and controller design of a non-isolated bidirectional hybrid-modular DC-DC Converter for DC grid applications. The DC-DC converter can be used to interconnect ...
Postfault operation of a nine-phase six-terminal induction machine under single open-line fault
(
Institute of Electrical and Electronics Engineers Inc.
, 2017 , Article)
This paper studies the postfault control of a nine-phase six-terminal induction machine (IM) during single open-line fault, which was recently proposed for high-power medium-voltage applications as a promising alternative ...
A Pulsewidth Modulation Technique for High-Voltage Gain Operation of Three-Phase Z-Source Inverters
(
Institute of Electrical and Electronics Engineers Inc.
, 2016 , Article)
Z-source inverter (ZSI) was recently proposed as a single-stage buck-boost dc-ac power conversion topology. It augments voltage boost capability to the typical voltage buck operation of the conventional voltage source ...
A Six-Phase 24-Slot/10-Pole Permanent-Magnet Machine with Low Space Harmonics for Electric Vehicle Applications
(
Institute of Electrical and Electronics Engineers Inc.
, 2016 , Article)
This paper proposes a six-phase surface-mounted permanent-magnet machine with a 24-slot/10-pole fractional slot winding, which not only eliminates the air-gap flux subharmonics, but also minimizes the effect of slot ...
Operation of three-phase modular multilevel converter (MMC) with reduced number of arms
(
Institute of Electrical and Electronics Engineers Inc.
, 2016 , Conference Paper)
Conventional three-phase MMC consists of six-arms, each arm is controlled to generate unipolar voltage ranging from zero to Vdc where Vdc is the input DC voltage. Each arm voltage has two components (DC and AC components). ...