بحث بسيط
السجلات المعروضة 1 -- 9 من 9
Positron annihilation studies of the effect of gamma irradiation dose in polymers
(
Elsevier Ltd
, 2003 , Conference Paper)
Positron annihilation lifetime (PAL) technique has been applied to study the effect of gamma irradiation dose on the structure of low-density polyethylene and polystyrene. The positron annihilation lifetime measurements ...
Positron annihilation lifetime study of helium ions implanted polyethylene blends
(
Trans Tech Publications Ltd
, 2004 , Conference Paper)
The structural defects of linear low density polyethylene (LLDPE) and high density polyethylene (HOPE) blends implanted with helium ions were investigated using position annihilation lifetime (PAL) technique. The positron ...
Electron irradiated low-density polyethylene studied by positron annihilation lifetime spectroscopy
(
Elsevier Ltd
, 2003 , Conference Paper)
A study of the degree and rate of cross-linking of low-density polyethylene (LDPE) as a result of irradiation by high-energy electron beam has been performed using positron annihilation lifetime (PAL) technique. The PAL ...
Tests of a diamond field-assisted positron moderator
(
Elsevier
, 2002 , Conference Paper)
Diagnostic studies have been performed on a 70 μm thick diamond film with a view to its development as a possible field-assisted moderator (FAM) for slow positron emission. The film was coated on one side with a 200 nm ...
Re-emission of slow positrons from tungsten at elevated temperatures
(
Elsevier
, 2002 , Conference Paper)
A series of measurements have been made on the dependence of the intensity and energy spectrum of slow positrons re-emitted from polycrystalline tungsten foil held at temperatures of up to 500 °C. Irrespective of target ...
Microstructure of heat-treated steel probed by positron annihilation
(2001 , Conference Paper)
Positron annihilation lifetime technique has been applied to study the microstructure change in steel after heat treatment. For this purpose, the specimens are heat treated in various manners; normalizing, annealing, ...
Ion beam modification of surface properties of polyethylene
(
Elsevier
, 2003 , Conference Paper)
Improvement of polymer tribological properties is an essential issue for their application when used as parts of machines or artificial human joints. Ion implantation is a very promising technique in this respect. This ...
Mechanical and thermal properties of gamma-ray irradiated polyethylene blends
(
Elsevier
, 2003 , Conference Paper)
In this work, the results obtained by gamma-ray irradiation of polyethylene (PE) blends are presented. The blends were produced by injection molding at 220°C with different compositional ratios, i.e. 100/0, 15/85, 25/75, ...
Compositional transformations in ion implanted polymers
(
Elsevier
, 2005 , Conference Paper)
Changes of surface layer composition produced by ion bombardment of polyethylene and polypropylene samples were studied. These materials are under consideration for load bearing surfaces in biological and technical ...